Saturday 20 August 2011

0

Switching Types

  • Saturday 20 August 2011
  • PRABH KARAN SINGH
  • Share
  •  LAN switch types decide how a frame is handled when it’s received on a switch port. Latency- the time it takes for a frame to be sent out an exit port once the switch receives the frame- depends on the chosen switching mode.







    There are three switching modes:
      
    Cut-through (FastForward) - When in this mode, the switch only waits for the destination hardware address to be received before it looks up the destination address in the MAC filter table. Cisco sometimes calls this the FastForward method.

    FragmentFree (modified cut-through) - This is the default mode for the Catalyst 1900 switch, and it’s sometimes referred to as modified cut-through. In FragmentFree mode, the switch checks the first 64 bytes of a frame before forwarding it for fragmentation, thus guarding against forwarding runts, which are caused by collisions.

    Store-and-forward - In this mode, the complete data frame is received on the switch’s buffer, a CRC is run, and, if the CRC passes, the switch looks up the destination address in the MAC filter table.

    fig.delimits the different points where the switching mode takes place in the frame.

    Cut-Through (Real Time)

    You may see Cisco call this cut-through, FastForward, or even real time. With the cut-through switching method, the LAN switch reads only the destination address (the first six bytes following the preamble) onto its onboard buffers. That done, it then looks up the hardware destination address in the MAC switching table, determines the outgoing interface, and proceeds to forward the frame toward its destination.
    A cut-through switch really helps to reduce latency because it begins to forward the frame as soon as it reads the destination address and determines the outgoing interface. With some switches, you get an extra super-cool feature: the flexibility to perform cutthrough switching on a per-port basis until a user-defined error threshold is reached. At the point that threshold is attained, the ports automatically change over to store-and-forward mode so they will stop forwarding the errors. And when the error rate on the port falls back below the threshold, the port automatically changes back to cut-through mode.

    FragmentFree (Modified Cut-Through)
    FragmentFree is a modified form of cut-through switching in which the switch waits for the collision window (64 bytes) to pass before forwarding. This is because if a packet has a collision error, it almost always occurs within the first 64 bytes. It means each frame will be checked into the data field to make sure no fragmentation has occurred.
    FragmentFree mode provides better error checking than the cut-through mode with practically no increase in latency. It’s the default switching method for the 1900 switches.

    Store-and-Forward

    Store-and-forward switching is Cisco’s primary LAN switching method. The store-and-forward method provides efficient, error-free transport instead of fast transport. When in storeand- forward, the LAN switch copies the entire frame onto its onboard buffers and then computes the cyclic redundancy check (CRC). Because it copies the entire frame, latency through the switch varies with frame length.
    The frame is discarded if it contains a CRC error-if it’s too short (less than 64 bytes including the CRC) or if it’s too long (more than 1518 bytes including the CRC). If the frame doesn’t contain any errors, the LAN switch looks up the destination hardware address in its forwarding or switching table to find the correct outgoing interface. When it does, out goes the frame toward its destination.


     Subscribe us via E-mail and Add us on Facebook for daily updates and Plz also do click once on the ads displaying below or above the post for us.. :)

    0 Responses to “ Switching Types ”

    Post a Comment